Overview
Surfaces move. Timber swells and shrinks, sheet metal flexes, and everything expands in the sun. A coating has to move with the surface or it cracks. The mandrel bend test measures how much bending a film takes.
What the test measures
The test measures a cured coating's resistance to cracking, or lifting from the substrate, when it is bent.
How the test is carried out
The method is ISO 1519.
- The coating is applied to a thin metal panel and left to cure.
- The panel is bent through 180° around a steel rod, called a mandrel, with the coating on the outside of the bend.
- The film is examined for cracks and for any lifting from the panel.
- The test is repeated on fresh panels with smaller mandrels until the coating fails.
Mandrel sets typically run from 32 mm in diameter down to 2 mm. The test can also be run on one agreed size as a simple pass or fail.
How to read the result
Smaller is better. The result is the smallest mandrel the coating was bent around without cracking.
| Result | What it describes |
|---|---|
| Passes a small mandrel | The film stretches a long way before it breaks. A flexible coating. |
| Passes only a large mandrel | The film tolerates a gentle curve but cracks on a tight bend. A more rigid coating. |
The tighter the bend, the more the outer face of the film is stretched.
What it means in use
Flexibility matters most where the surface moves or flexes. That covers cladding and roof sheets, gates and railings, timber, and roof tiles that heat and cool through the day. A film that cannot stretch cracks, and water gets in at the crack.
What the result does not tell you
Flexibility is measured on a new film at laboratory temperature. Coatings stiffen in the cold and can become more brittle as they age and weather. A film that passes when new can crack in its tenth winter.
Flexibility trades against hardness. The properties that let a film bend generally make it softer, and the hardest coatings are the least flexible. Neither is better in itself. The right balance depends on the surface. See Hardness (Pencil Test).
A bend test on a metal panel is not a crack-bridging test. It does not show that a coating will span a crack that opens in masonry or concrete.
On our product pages
Where a product has been tested, its page shows the result, the method and, where the method has one, the rating. Results published on this site come from internal testing to the stated method. They are given for technical reference and comparison.
If a figure you need is not shown, ask our technical team.


Share:
Scratch Resistance (Sclerometer)
VOC Content