DESCRIPTION
TarmaFix Flow is a pourable tarmac repair mortar for potholes, depressions and eroded areas in asphalt and tarmac. It is a fibre-reinforced, polymer-modified cement powder. Mixed with clean water, it becomes a fluid mortar that runs into the damaged area and settles level under its own weight.
This is not a bituminous cold-lay product. Cold-lay tarmac has to be tamped or rolled to compact it. TarmaFix Flow needs no compaction: pour it in, let it settle, and finish with a steel float where needed. The polymer improves bond to the existing surface. The fibres reinforce the cured mortar against cracking and wear.
It fills damage up to 100mm deep in a single pour. Deeper holes are built up in layers. It sets fast, so a car park, yard or loading area returns to use within hours rather than days. It also bonds to concrete, so one product covers asphalt, tarmac and concrete patches on the same site.
Recommended areas of use
- Car parks
- Driveways
- Loading bays and access routes
- Paths and walkways
- Industrial yards
- Internal asphalt floors
- Potholes, depressions, dished areas and surface erosion in external tarmac
- Patch repairs to concrete
Features
- Pourable consistency: the mortar runs into the hole and finds its own level, so there is no compaction and little trowelling.
- Fibre reinforcement throughout the mix holds the cured repair together under traffic and resists cracking.
- Polymer-modified cement bonds to asphalt, tarmac and concrete without a separate primer in the specification.
- Rapid set: foot traffic and forklift traffic return on the same day, which keeps downtime short.
- No heating and no hot-asphalt plant: mix and pour from a bucket on site.
- Applies to damp substrates, so a repair can go ahead after rain once standing water is cleared.
- Interior and exterior use.
- Low VOC content, below 30 g/l, and tools clean with water before the mortar hardens.
Good to know
- The cured repair is dark grey and cementitious. It will not match the black of surrounding tarmac, and it is rigid rather than flexible.
- Do not apply to newly laid asphalt. Fresh asphalt carries surface oils and still moves, which can weaken the bond and crack a rigid repair. Let new surfaces age before repairing them.
- The substrate must be sound. Do not pour over loose or unstable asphalt.
- Damp is acceptable. Standing water is not.
- The mortar relies on flow, so the repair area needs to be reasonably level. Do not use it on steep slopes or vertical faces.
- Pot life is short. Mix beside the repair and only mix what you can place straight away.
- Edges can be feathered to blend into the surrounding surface, but the thinnest edges do not carry the strength of the full-depth repair.
- Cure times lengthen in cold weather and vary with repair depth and site conditions.
- Shelf life is 12 months. Store between 5°C and 30°C.

